Jeg synes ikke at kunne finde lignende emne.
Jeg står nemlig med 20 hoveder som jeg har fået af en ven, som han godt vil sponsorer til dette forsøg.
Jeg har tænkt mig at bruge en artikel på erwoid, hvor der er en fremgangsmetode til fremstilling af heroin, fra plante til slutprodukt.
Jeg vil starte med at blende hovederne til grød i lidt vand med citronsyre til ph 2-3. Det skal så i en gryde og stå og simre, men ikke koge, i en times tid, ligesom når man lave the. Efter en times tid filtreres det igennem kaffe filter også springer vi over til erowid:
Processed opium is stirred in large drum of boiling water until it has completely dissolved. Slaked lime (calium hydroxide), at about one-fifth the mass of opium (8), (or a fertilzer with a high lime content) is added to the solution. This has the effect of converting morphine, insoluble in cool water, into the soluble salt, calcium morphenate. For the most part, the other alkaloids do not react, and when the mixture is cooled, the morphenate remains in solution, while the other chemicals settle to form a brown sludge at the bottom of the container. (Codeine is somewhat soluble in water and some amount is likely to remain in solution). The calcium morphenate solution is scooped or poured from the drum and filtered and pressed through burlap rice sacks or some other makeshift filtration apparatus. The filtered solution is re-heated, but not boiled, in cooking pots to which ammonium chloride is added at about one-fourth the mass of opium processed (8). After the pH of the solution reaches 8 or 9 it is cooled. Within a few hours, morphine base and any remaining codeine precipitate out of solution and settle to the bottom of the pot. The solution is then poured off through cloth filters, leaving chunks of morphine base on the cloth, which are squeezed dry and set aside to dry further in the sun. The dried crude morphine base is a coffee-colored powder. (A more scrupulous chemist might use ether in the filtration to dissolve any residual codeine out of the base mixture, but this is not reported in accounts of illicit manufacture).
From this point, some manufacturers may proceed directly to step 3. Ideally, however, the crude morphine base is purified by dissolution in dilute hydrochloric (or sufuric) acid, forming a solution of morphine hydrochloride (or sulfate). Activated charcoal is added, and the solution is heated and filtered hot through a fine cloth. The filtration is repeated several times, removing the charcoal and colored impurities with it. The filtrate may be dried in the sun to leave behind morphine hydrochloride, a fine white powder if purification is complete, which may be pressed into 1 kg bricks and transferred for further processing at a remote site. Alternatively, ammonium hydroxide may be added to the morphine HCl solution (or re-dissolved morphine HCl), precipitating morphine base, filtered and dried to form a granular solid (8).
Log ind
Tilmeld
OSS
Søg
Glæder mig til at høre om resultatet.
