Hej psychedelics
Jeg får snart mit første growkit hjem(Cubensis Mexico (Dutch King)). Jeg har aldrig prøvet at grow'e selv så vil jeg gerne gøre det helt rigtigt! Da alle growkits ikke er ens vil jeg gerne prøve at forklare hvordan jeg tror mit virker.
Jeg får en beholder + x-antal spawnbricks. Så skal jeg proppe spawnbrick'sne ned i beholderen og fylde den med vand og vente i 10min og så hælde vandet fra. Og så lade den gro. Er det ikke mere eller mindre rigtigt?
Jeg ville gerne linke til det kit jeg har købt, men det mås man jo ikke. Der for har jeg klippet lidt tekst fra forhandlerens side:
<b>Spawnbricks:</b>
1. Work clean, so spring-clean your hands and the workspace.
2. Remove the clingwrap and the pasteboard. Now aerate the earth to the approximate depth of
0,5 cm with a clean knife (a skalpel-blade would fit best) and soak the casing with 100 ml water.
Take clean fresh drinking-water.
3. When the ideal environmental conditions are acchieved put the mycelbricks into the breeding-set.
a. Cubensis species need an air humidity of 95-100 % for their pinning-phase. As the pins
(mini-mushrooms) are seen, the humidity should be reduced to 89-92 % to
prevent bacterial affection!
b. The optimal temperature for cubensis is between 23-26 ° C (73,4-78,8 °F).
c. Take care that the brick gets light, but nor direct sunlight!
5 – 10 hours a day will be enough.
d. If you cultivate your bricks in a sack or a terrarium (no grow-kit), ventilate minimum twice, so the
CO2 can pass of and the mushrooms don 't choke.
It takes 10 to 14 days for the pins to appear.
4. The growth-cyclus of the cubensis-species ends with the fine skin (Velum) being detached from the
hat. The fruiting body appears just until the mushroom has dropped the spores. Now all the fruiting
bodies, even the tiny runts, must be removed.
5. Now aerate the earth to the approximate depth of 0,5 cm with a clean knife (a skalpel-blade would
fit best). Bend the aluminiumbox open and pour circa 0,5 l of water (until the brick swims slightly)
into it. After 20 minutes pour the rest of the water out and and soak the casing with 100 ml water.
6. After the rehydration putt he brick back into the breeding-set. Within a few days you will see the
pins again.
7. If you don 't use the brick immediately you can store it in your fridge at 4 °C (39 ° F) until the
expiry date on the pasteboard.
Det er ikke så svært vel? Er der noget jeg bør vide eller nogle tips til hvordan jeg får de flotteste svampe?
men vil gerne være helt sikker!